rivadynamite hat geschrieben:ich wüsste aber gerne, was für Änderungen die 1.47 gegenüber meiner 1.42er-FW mitbringt...

V RF.01.47 (2020-06-16) …

- Adding of support for the RF2000v2.
- In case there are two extruders present, the to-be-used extruder(s) can be chosen within the "Configuration" -> "General" -> "Extruders" menu now.
- In case only the left or only the right extruder is chosen here, there is more printing space available in x-direction.
- Fine-tuning of PID values.
- Fine-tuning of PWM frequencies.
- The extruders are being moved to the home position automatically in case the alignment of the extruders is being started.
- In case the alignment of extruders has been started but is not continued and completed within 60 minutes, the extruders are being turned off and the alignment must be restarted afterwards.
- After the end of the heat bed scan, the according information message is being displayed until it is acknowledged by the user.
- The message about the overdrive of an endstop has been changed from an error to an information message.
- In case a temperature sensor error is detected, there is one additional safety line which shall ensure that all heaters are being disabled.
- In case the operating mode has been changed to milling, only one of the potencially present two extruders was disabled.
- Minor clean-ups.
- Special thanks apply to the following users from the forum at rf1000.de, because they have provided outstanding information and support for several changes from this version:
- Nibbels